If the X and Y value of the monitor and the target is not consistent, the target can be calibrated
This can be done by moving the logical center on the target (Offset)
Set up the targets at least 30 minutes before testing for the temperature to stabilize.
Put a paper sheet or a transparent paper in front o fthe aiming area.
Tip: Use plastic wrap/shrink wrap. Easy to use. Easy to see the aiming.
Fire a shot close to the centre.
Measure the lenght from the shot to the centre of the aiming.
X is horizontal direction.
If the shot is on the left of the centre, the horizontal lenght should be marked with a - (negative).
Y is vertical direction.
If the shot is on the below the centre, the vertical lenght should be marked with a - (negative).
Read the X and Y value on the monitor
Example. Read the values on your screen.
Read the X and Y value on the monitor
X is horizontal direction.
If the shot is on the left of the centre, the horizontal lenght should be marked with a - (negative).
Y is vertical direction.
If the shot is on the below the centre, the vertical lenght should be marked with a - (negative).
Example: X = -8,1 og Y = 8,3
On the monitor select:
Menu - System setup - Advanced - Target Config
Example. Input the values from your monitor.
The new offset to be saved on the target:
Offset X:
Offset Y:
Press Edit.
Change the Offset X and Offset Y to the new values.
Press Send Data to save.
Set up the targets at least 30 minutes before testing for the temperature to stabilize.
New offset X:
New offset Y:
