Set up the targets at least 30 minutes before testing for the temperature to stabilize.
Put a paper sheet or a transparent paper in front o fthe aiming area.
Tip: Use plastic wrap/shrink wrap. Easy to use. Easy to see the aiming.
Fire a shot close to the centre.
Measure the lenght from the shot to the centre of the aiming.
X is horizontal direction.
If the shot is on the left of the centre, the horizontal lenght should be marked with a - (negative).
Y is vertical direction.
If the shot is on the below the centre, the vertical lenght should be marked with a - (negative).
Read the X and Y value on the monitor
Example. Read the values on your screen.
Read the X and Y value on the monitor
X is horizontal direction.
If the shot is on the left of the centre, the horizontal lenght should be marked with a - (negative).
Y is vertical direction.
If the shot is on the below the centre, the vertical lenght should be marked with a - (negative).
Example: X = -8,1 og Y = 8,3
On the monitor select:
Menu - System setup - Advanced - Target Config
Example. Input the values from your monitor.
The new offset to be saved on the target:
Offset X:
Offset Y:
Press Edit.
Change the Offset X and Offset Y to the new values.
Press Send Data to save.
Set up the targets at least 30 minutes before testing for the temperature to stabilize.
New offset X:
New offset Y: